View Full Version : Bulk Head Repair
JLynch
10-23-2008, 03:38 PM
Hi i am just about to start repairs on my Series III (74) left hand drive bulk head. Before i begin to cut and replace is there a spec. sheet available for measurements. Main replacements will be made in the floor panels and door posts.
Thanks for any help,
Jerry
solihull109
10-23-2008, 07:48 PM
Find someone with a jig,... measurements are needed, but a jig is essential.
Find someone that replaced their frame and make your own jig by cutting out the section the the bulkhead bolts into . Mount your bulkhead before cutting any rotted section out of your bulkhead.
FWIW etc.
Powered by vBulletin® Version 4.1.9 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.