View Full Version : WTB Warn winch controls
Hammertime
02-03-2009, 07:06 AM
I need one of these anyone have a old junk winch setting around and want pat with the contols?
crazyfish
02-03-2009, 08:38 AM
there is a thread in here somewhere about vintage winches, and in that thread was a few links to where you could get a generic replacement.... I'll look in a bit.
galen211
02-03-2009, 08:51 AM
http://www.piercearrow.us/pierce_control_remotes.htm#Rubber%20Remotes
http://www.piercearrow.us/more_towing_accessories_1.htm#4%20Pole%20Connector s
http://forum.roversclub.org/forum/showthread.php?t=542&highlight=warn+winch
I used the Pierce Wrecker P040 controller (you can see a picture in the thread). I also bought their mating connector and put that on the truck, wired right into the warn wires.
It was WAY cheaper than buying a warn controller.
firemanshort
02-03-2009, 12:40 PM
Depending on what you want to do...
http://www.roadlessgear.com/Merchant2/merchant.mv?page=RGJ/PROD/R/RG631
You might consider dash mounted controls...
Hammertime
02-03-2009, 07:49 PM
I need one of these anyone have a old junk winch setting around and want pat with the contols?
I guess I need to make myself more clear, I need the solenoid pack and the cover.
flippedrover
02-04-2009, 09:12 AM
I guess I need to make myself more clear, I need the solenoid pack and the cover.
For what make and model?
galen211
02-04-2009, 09:22 AM
I have one from an 8274.
But if I were you I would replace it with an Albright solenoid.
https://www.expeditionexchange.com/superwinch/
Scroll down the page to see the albright. This one solenoid replaces the whole pack. I have this mounted in my Series to run my Warn winch and it is great.
Hammertime
02-05-2009, 07:29 AM
I have one from an 8274.
But if I were you I would replace it with an Albright solenoid.
https://www.expeditionexchange.com/superwinch/
Scroll down the page to see the albright. This one solenoid replaces the whole pack. I have this mounted in my Series to run my Warn winch and it is great.
Can I just use the one or do I need four like the Warn?
the winch is a M4500 that I am going to use on my Polaris Ranger, On the Warn web site it looks like it take the same one sa the 8000 and so on.
galen211
02-05-2009, 08:15 AM
You only need that one, it replaces the pile of solenoids that come on a Warn. It is the size of a pack of cigarettes.
Powered by vBulletin® Version 4.1.9 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.