View Full Version : Polly bushings for Rovers
Rhich
12-02-2005, 11:13 PM
Who’s’ done polly bushings in their Rovers?
Any advise they wish to share?
Any items that should be looked at while doing bushings?
Estimated time frame to do bushings?
JohnC
12-12-2005, 03:30 PM
I have the orange bushings from Polybush (made exclusively for Scorpion Racing). Installing them was a piece of cake 'cause I installed all new components (trailing arms, radius arms, adjustable panhard rod, etc.).
They are a two piece design so the worst part of the install is getting the old ones pressed out.
I ran the red Iron Man bushings on my CJ7 and they were too hard. I heard the blues are softer but don't last as long.
I don't think anyone on this board has tried the Orange Polybush (except for Randy Maynard who is in the process of installing a set).
Good luck.
Powered by vBulletin® Version 4.1.9 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.