New D2 Parts Truck just in

[pushngo]

Blue with tan interior / black piping

Not too many body panels It was rolled ..a couple of times

All interior seem fine

Brand new ...less than 500 mi front drive shaft.$538 new ..$300

Hubs $115 ea

rear ladder will fit D1 or D2 $75

Rhino spare tire cover $25

Cup holders $40

New Battery less than a week old paid $97 ...$60

Let me know what you need

I also have a disassembled D2 engine for parts

Still lots of D1 and RR parts

10 spline 3rds $65

Axles 10 spline $35 rear $65 front

Hubs complete $65

[scatterling]

mmm...will the ABS front wheel sensor fit the D1?

[pushngo]

mmm...will the ABS front wheel sensor fit the D1?


No I'll get you one one of these days.

Any more issues with the alarm?

[Tom109]

What size is spare tire? Will the cover fit 245/75's or 7.50x16's ???

Does it have a pair of 3rd row seats?

Tom P.

[Frank84]

Could use a few things for my dad:

front fog lights if a '99-'02 DII and they didn't crack in the roll
rear wiper motor
if 7 seats - a trim piece that goes on each side (assuming this isn't what Tom is looking for)
both front windshield washer nozzle/jets that sit in the hood

[pushngo]

I will check on the seats and fogs tonite I have a couple of D2s that I am getting ready for resale Let me see what I have for fogs

[rvrsrvc]

And I just bought another D2 this morning. Planning to pick it up Friday and decide what to do from there. Runs and drives, but has severe coolant loss.

[scatterling]

No I'll get you one one of these days.

Any more issues with the alarm?


-- no more issues, disconnected all the wires and all seems fine. Wish I knew why it was in there in the first place!

[Rob P]

but has severe coolant loss.

Define Severe. They make more coolant every day. Could be just the thing to put that 6.5 N/A GM diesel into that you've always secretly (so secret even you didn't know) wanted to do.

[pushngo]

What size is spare tire? Will the cover fit 245/75's or 7.50x16's ???

Does it have a pair of 3rd row seats?

Tom P.


The spare tire is a 255/65 which is 29.1 a 245/75 is about 30.5

I have 4 D2s and they all have buckets as Trevor said there is a new one coming in tomorrow but I believe it has Grey interior. I have called a friend who had a bunch at MAR mabe he has some still. Did you want the whole setup or just parts?

[pushngo]

Could use a few things for my dad:

front fog lights if a '99-'02 DII and they didn't crack in the roll
rear wiper motor
if 7 seats - a trim piece that goes on each side (assuming this isn't what Tom is looking for)
both front windshield washer nozzle/jets that sit in the hood

Frank I have a set of Hella 500s which were not stock to a D2 mabe the new truck will have a set I will let you know

I pulled a rear wiper motor for you and 1 washer nozzle and 10 or so of the clips you are going to break.

[Frank84]

Thanks Randy!

I'll certainly take the motor, nozzle, and clips. Is the second windshield washer nozzle broken?

Thought of another thing for a DII - how about the cruise control pump/motor that sits on the passenger side inner fender under the hood? The more I sit here and think the more little things I come up with....do you have the little elbow tubes that are under the hood that go from the washer nozzles to the rest of the tube system? Actually, I should just grab the tubing all the way to the washer tank or as close as you can reasonably get.

[Rob P]

Frank, you should just knuckle down and buy a whole parts truck. That way you'll have it covered. (Oh and I will be needing some parts also)

[pushngo]

Thanks Randy!

I'll certainly take the motor, nozzle, and clips. Is the second windshield washer nozzle broken?

Thought of another thing for a DII - how about the cruise control pump/motor that sits on the passenger side inner fender under the hood? The more I sit here and think the more little things I come up with....do you have the little elbow tubes that are under the hood that go from the washer nozzles to the rest of the tube system? Actually, I should just grab the tubing all the way to the washer tank or as close as you can reasonably get.

I have the pump I tossed the lines so if Trevor dumps the garbage before I get there they are gone and yes I would just get new rubber line and run it al the way and loose the elbows The hose gets brittle with the heat and age that's why the 2nd nozzle didn't make it

Send me a list and I will get it all in one package for you I will be out there again on Thurs

[eli.s]

Randy,
I'm looking for the poly covers on the bottom of the BRUSHBAR for my disco 2
and do you still have the ladder?
thanks
eli

[pushngo]

I have the ladder and which bush bar do you have I have the round ones that go into the bottom but not the big "foamy" piece that was on the newer ones

[Tom109]

Randy,

I was looking for a set of something like this:
http://carphotos.cardomain.com/ride_images/3/1776/3721/29439360005_large.jpg

Do you have a matched set in tan?

Do you know if all D2's had the head restrain attached to the roof? I'm thinking of fitting them to the rear of my 109...

Tom P.

[pushngo]

Hey Tom I have 4 D2s here and they all have buckets not jump seats. I have looked around and no one seems to have Jump seats I may have a D1 coming in with a set but they drop from the side and face each other. I would assume if they dropped forward facing like that they would have to have the headrest.

[Tom109]

Thanks Randy. If you do find a pair, let me know...

Tom P.

[eli.s]

I have the round one
http://picasaweb.google.com/elispigler/MYLandRover#5420756060188083794

how much for the ladder?

[pushngo]

I have the round one
http://picasaweb.google.com/elispigler/MYLandRover#5420756060188083794

how much for the ladder?

I have some of those somewhere I will have a look around $75 for the ladder and if I can find a couple of plugs I will throw them in the box What is your Zip I will figure out shipping or will you be in the area Come on over for RC on Fri and take it from there.

[eli.s]

Randy,
PM