soncjet
05-25-2012, 12:28 PM
the company i work for makes reproduction soft goods for (mostly) American Muscle era cars... however, we go back into the 30's and up to the 90's with parts and pieces... and get into other makes and models as things arise.
during my "trying to get my rover started" period, i pulled the passenger side under dash trim panel out to get up to the relays etc. I'm not sure if the 95 RRC underdash is a 1 year only... or if the changes were on the top only.
15631564
I wasn't sure if anyone might be interested in this kind of thing or not? as long as we have an original to make a pattern off of, and it's not a molded part - we can usually figure out something to make it work.
something else that might be of interest, would be hood insulation pads. they would not be molded like original, but would be in the same shape, pattern, hole location, clip location as the originals have. i haven't gotten around to taking mine off to pattern it, but i will one of these days when i have a free moment.
some of the other things we get into that could cross over to rover stuff....
- jute padding
- jute padding with a mastic coating on it
- various insulations for hood and firewalls
- masticated rubber for a-seals, and various flat cut gaskets etc
- neoprene for seals etc
- panel board for things like this under dash trim cover.
- there are prob more things that we could do - just haven't had anyone request things.... yet.
all things are made here in the Annville, PA area. I'm sure we could set something up with a local shop (at no cost to them), that the orders go thru there, and we can drop ship from here. just need to find a local rover shop.....
during my "trying to get my rover started" period, i pulled the passenger side under dash trim panel out to get up to the relays etc. I'm not sure if the 95 RRC underdash is a 1 year only... or if the changes were on the top only.
15631564
I wasn't sure if anyone might be interested in this kind of thing or not? as long as we have an original to make a pattern off of, and it's not a molded part - we can usually figure out something to make it work.
something else that might be of interest, would be hood insulation pads. they would not be molded like original, but would be in the same shape, pattern, hole location, clip location as the originals have. i haven't gotten around to taking mine off to pattern it, but i will one of these days when i have a free moment.
some of the other things we get into that could cross over to rover stuff....
- jute padding
- jute padding with a mastic coating on it
- various insulations for hood and firewalls
- masticated rubber for a-seals, and various flat cut gaskets etc
- neoprene for seals etc
- panel board for things like this under dash trim cover.
- there are prob more things that we could do - just haven't had anyone request things.... yet.
all things are made here in the Annville, PA area. I'm sure we could set something up with a local shop (at no cost to them), that the orders go thru there, and we can drop ship from here. just need to find a local rover shop.....