PDA

View Full Version : Defender Parts For Sale



tikicar
01-01-2007, 01:18 PM
I have a bunch of Defender parts for sale. These were off a 1994 and were removed when it had 28,000 miles. I don't want to ship this stuff so it must be picked up. Located in York, Pa. If you buy more than one item take $10.00 off each additional item. Thanks, Scott




5 original wheels with BFG Mud Terrains. Spare never used, 4 other 50% tread
$400.00

Original Radiator, Radiator Fan, Fan Shroud
$100.00

Original Alternator
$45.00

4 Stock Springs, 4 Stock Shocks, Steering Stabalizer, 4 Bump Stops
$40.00

Stock Twin Tube Side Steps
$200.00

Stock Under Seat Heater
$40.00

Front & Rear Sway Bars
$30.00

Stock tie rods (just tubes, no ends) , Rear trailing arms
$40.00

Complete Front & Rear Drive Shafts
$100.00

Factory Wrap Around Brush Guard
$100.00

Stock Rear Step Bumper
$150.00

Stock Front bumper with lights and winch plate
$100.00

Rear Tire Carrier (just center swing part no brackets)
$75.00

Factory Tail Light Guards (no bolts)
$40.00
---------------------------------------------------------------------------------------------------------------------

Defender 110 Parts Parts taken off with about 50,000 miles Lockers and rear disc brakes were added, that is why parts were removed (this is not a complete rear Salsbury axel. Just parts)

Factory Front & Rear axel carriers

Salsbury Rear axel shafts, Complete rear drums & backing plates with brakes, wheel cylinders & hardware on them. With rear hub assembleys

Original 5 Michelin X tube type tires 7.50 R16 (two 70% tread, three 40-50% tread)
$200.00 for everything

galen211
01-01-2007, 03:59 PM
I'm interested in the front bumper and will be in York tomorrow. Any pictures? My cell number is 570-898-4280.

Some of you guys would know better than me but a D90 bumper will fit a Series III correct?

thanks,
Galen

tikicar
01-01-2007, 07:11 PM
Will be at the shop all day tomorrow. I left you a message on your cell phone. Thanks, Scott

Tom Bache
01-13-2007, 10:56 PM
Galen,
You will need to trim the lower mounting tabs narrower to slide into the chassis front spring hangers. The bumpers sits closer to the wings as those same tabs are shorter. BTDT.

Tom Bache

Tom109
02-14-2007, 01:06 PM
Scott,

Are you going to SCC? I'd like to take alook a that heater. Or youy could e-mail/post a few pics..?

Tom P.