need help with turn signals and Hazard Lights

[mikefal]

they just stopped working both the turn signals and the hazards???? check the fuse box under hood and the box under the steering wheel is there any other fuse box

[rvrsrvc]

I would take a look at the hazard switch- in order to change the light bulb in the clock, one might have disconnected the harness on the back of the switch and maybe it's not fully seated. The t/s need the hazard switch in line to function.

[mikefal]

no just checked that. I did find a wire on the left bumper light that was chafed and could of shorted out on the bumper. is there a relay or a fuse somewhere else that could have blow ?? when it started the turn signals went first then about an hour later the hazards? the light in the dash does not light any more to

[rvrsrvc]

F1 (15amp) in the under dash fuse box and F4 (30amp) in the under hood fuse box supply power first to the hazard switch and then into the fuse box where the t/s flasher unit is located.
Trailer wiring? I had a Disco in here last week that had a completely smoked signal convertor. I mean, it let all of the smoke out. Thank goodness for fuses, but it left him stranded at a Taco Bell drive through with a trailer and the Rover in park!

[mikefal]

could i have fryed the wires in the dash somewhere or the hazard switch its self

[Rob P]

I would think that cooking the wires would be unlikely but anything is possible.



Hey Trevor, when are you gonna pick up that blue range rover under the wrightsville exit bridge?

[mikefal]

ok i got the t/s and hazards to work both switches fried now the the problem is the trailer light indicator comes one with the right side t/s any ideas .


thanks for all the help
mike

[scatterling]

mine does that too. I assumed it was normal.

[galen211]

Does the trailer indicator come on or just flash when you first apply the turn signal?

[sven]

It should just flash once with the signals, this is normal on a D1